Installation Guide
Proximity Readers
CSI Readers
43
10.
From a host workstation, configure I/NET to use the Hughes proximity reader.
Common settings are:
✧
Reader Type: Wiegand 26-bit
✧
LED Polarity: Anode
✧
Door Mode Schedule:
–
“PIN Enable” to require both a card read and PIN entry
–
“Secure” to require a card read only
✧
Key/Card Translation: If the DPU is configured to enable Wiegand 26-bit
key/card translations, perform these translations as necessary using the I/NET
Key/Card Translations editor. Refer to TCON116,
DPU-7910A Installation
Guide
, or TCON117,
DPU-7920 Installation Guide
, for the necessary DIP
switch setting to enable Wiegand 26-bit key/card translations.
Refer to the I/NET 2000 System Operator Guide or Technical Reference Guide for more
information concerning I/NET 2000.
PIN Pad Operation for the Motorola/Indala and Hughes Readers
Prior to a card read, the LED on the PIN pad is off. After a valid card read, if the door is
in PIN mode, the LED on the PIN pad will alternate between red and green for up to 15
seconds. During this time, the user must enter a 5-digit personal identification number
(PIN). As each digit is entered, it is sent immediately to the DPU. If an incorrect digit is
pressed, the user may press the asterisk (*) key to clear the memory and reenter the entire
PIN. The * key can be used twice during the PIN entry sequence (pressing the * key a
third time will terminate the entry sequence and require the user to start over with a valid
card read). Pressing the fifth digit or the pound (#) key ends the PIN entry sequence. If
less than 5 digits have been entered when the user presses the # key, then all digits that
Figure 25. Hughes ProxPro Connections
1
2
3
4
5
6
8
DATA 1
+12 VDC
From Reader
GREEN LED
GROUND
RED LED
DATA 0
7
SHIELD
To DPU-7910A
Series Controller
+12 VDC
Linear Power
Supply
–
+
Breakout Box Connections:
TB3 or TB4
1
2
3
4
5
6
7
8
DATA 1
DATA 0
RED LED
GREEN LED
GROUND
+12 VDC
From Reader
SHIELD
+12 VDC Linear
Power Supply
+
–
DPU-7920 Connections:
Summary of Contents for CARDPIN1
Page 5: ...Installation Guide CSI Readers v Specifications 45 Index 49...
Page 58: ......
Page 59: ......
