WHAT YOU NEED TO KNOW FIRST.
Contamination of the top track.
It is essential when installing CS TrackSystems
that all dust, swarf or contamination is removed
from the inside of the track before fitting your
door.
Ensure tracks are securely and adequately fixed
to the framing/lintel on site and are running level
to guarantee a smooth running door.
Follow the preparation instructions below, then
turn to page 3 and follow the relevant track
installation instructions.
PREPARATION.
1 Fit the mounting plates
(drawing R).
Drill front and rear holes 125mm in from the
edge of the top of your door leaf as shown
(drawing R).
Note: these mounting plates must be placed
exactly in the centre of the door thickness.
At the bottom of each door leaf, cut a groove to
the dimension and tolerance shown.
Make it central to the door thickness and
absolutely straight.
Screw the mounting plates to the doors, making
sure the black plastic stop is facing the edge of
the door.
sliding door track.
or
1
2
PAGE
PAGE
Before you start:
Edge of
door leaf
© CS Cavity Sliders Pty Ltd.
125mm to
centre of the
boss hole
Fit the 6
screws as
shown
125mm
Black
plastic
stop
Drill ø25mm (1”)
x 13mm deep.
Face of
door leaf
T-Guide
PREPARING THE DOORS
See point 1.
20-21mm
5-5.5mm
Go to page
3
(overleaf)
© CS Cavity Sliders Pty
. Ltd.
CS
TRACKSYSTEMS™
(O.D. 2008).
60396/AU / ZNI070 - 02.2018
Check out the full range of products and use
our on-line calculator at: www.cavitysliders.com.au
Installation
Instructions
READ these
CAREFULLY
!
Installation
Instructions
Another quality product from:
