Safety instructions
VX 570 English V1.10
Page 7 of 44
4.3
General safety instructions
Note
▶
Work on power-operated equipment may only be carried out
by trained, instructed or by authorized personnel.
Note
▶
Without consultation and approval of CS Instruments GmbH
& Co. KG the warranty claim is void in case of modification works
which are not listed in this operating manual. This symbol is used
at points in the operating instructions where special attention
must be paid to ensure that the guidelines, regulations,
instructions and the correct sequence of operations are observed
and damage and destruction are prevented.
Risk of injury and accidents during operation outside the permissible
ambient/operating conditions or operating temperatures due to excess
pressure or faulty installation. Depending on the application, the pipeline
pressure can be up to 40 bar / 580 psiG depending on the application
.
Ensure that the flow sensor is only operated within the permissible limit values (
→
type plate, specified max. PS pressure) and that the measuring range end values
are taken into account.
Risk of injury due to unauthorized device modifications, incorrect
installation or damaged components.
The operating permit becomes
invalid in these cases.
Operation is only permitted with original
components.
Only operate the flow sensor when it is completely assembled. Do not operate a
damaged sensor and prevent further use until it has been repaired. The sensor
must be checked and maintained regularly by instructed and qualified persons.
Device modifications are not permitted and release the manufacturer from any
warranty and liability.
Explosion risk in Ex-protected areas due to ignition of explosive
substances when sparks are generated.
The flow sensor does not have
Ex approval! Do not use the flow sensor in Ex-protected areas.
4.4
Environmental protection
The flow sensor and also the packaging contain recyclable materials
which must not be disposed of in the residual waste. Dispose of the
packaging materials and the flow sensor in an environmentally friendly
manner at the end of its service life in accordance with the regulations
applicable in your country.
The used operating and auxiliary materials as well as replacement parts
produced during operation of the flow sensor must be disposed of in
accordance with the environmental protection regulations.
DE: Disposal code according to Waste Catalogue Ordinance (AVV)
16
02 14
, electrical and electronic devices and their components.
