Part III: Operating the Trencher
13
4.
Using an intermittent pulling action, pull the trencher toward you 4 to 6 inches then
relax your pull, allowing the trencher to again reach the chosen depth.
5.
Repeat this action until you have finished the job. The wheel lock will aid you in this
operation by helping to hold the trencher in position until the next motion is started.
Stopping
There are two stop switches on the trencher; one on the handle bar and one on the engine.
Refer to the engine manual for the switch location on your trencher. The operator can turn
the trencher off at any time by switching either stop switch to the “OFF” position. Both
switches must be “ON” before the engine can start.
Stopping the engine following the procedures:
1.
Switching stop switch on handle.
2.
Move the Throttle Lever to IDLE.
3.
Recoil Start: Turn the Ignition Switch to the OFF position.
4.
Electric Start: Turn the Key to the OFF position.
When Blocked
If the Chain stops moving while digging trenches, the engine should be stopped, take out the
muds or anything which stuck the chain, then restart the engine, and start digging again.
Operator Safety
WARNING
A.
All the rack and pinion should be greased before every use.
B.
Always wear the proper clothing and protective gear. Eye and ear protection, hard hat,
boots, gloves and dust masks are that may be required.
C.
Keep hair, fingers, and all other body parts away from openings and moving parts.
Always wear, long pants, boots, and gloves. Secure hair so it is above shoulder length.
D.
Do not operate trencher indoors. Outdoor use only.
E.
Do not operate trencher when tired, ill, or under the influence of alcohol, drugs, or
medication.
F.
Always assume the digging location contains underground utilities. Contact appropriate
utility company to determine where electrical cables, gas lines, water lines, etc. are
buried before operation.
G.
Always use extreme caution while operating tool. Be sure of your footing and physical
capabilities.
Tools Safety
CAUTION
A.
Inspect entire trencher before each use. Replace damaged or worn parts.
B.
Check for fuel leaks and make sure all fasteners are in place and securely fastened.
C.
Replace digging blades that are severely worn. Be sure the digging chain and engine is
not moving.