background image

 
 

Page 2 of 15 

 

** THIS UNIT MUST BE INSTALLED AND EARTHED BY A 

LICENSED PLUMBER ** 

 

 

 

WARNING   

 

To prevent risk of electric shock, make sure this system is 

 

properly earthed and protected by a safety switch. 

 

Pull the plug before servicing or replacing lamps. 

 

Keep all connections dry and off the ground. 

 

Do not touch the plug with wet hands. 

 
 

WARNING  

 

Do not look directly at the UV lamp when it is operating. 

 

The light emitted by the lamp can cause serious damage to eyes  

 

and burn unprotected skin. 

 
 
 
 

WARNING 

 

This unit must be installed by a licensed plumber. 

 

Read manual before installing or servicing the system. 

 

Only experienced technicians who possess a strong understanding  

 

of the system should attempt to replace lamps or service it. 

 
 

To guard against injury, basic safety precautions should be observed including the following: 

 

1.

 

Read and follow all safety instructions. 

2.

 

Ensure the unit is properly earthed before operating. 

3.

 

The power supply must be protected by a Residual Current Device (Safety Switch) 

4.

 

Since water is employed in the use of this system, special care should be taken to avoid possible electric shocks.  

DO NOT attempt to repair the system yourself.  Contact an authorized service facility for service. 

5.

 

DO NOT operate the system if it has a damaged cord or plug, if it is malfunctioning or if it has been dropped or damaged 

in any manner. 

6.

 

Before servicing or cleaning, unplug the system. Never pull the cord to disconnect plug from power supply. Grasp the 

plug and pull to disconnect. 

7.

 

DO NOT use the system for anything other than its intended purpose. The use of attachments or accessories not 

recommended or sold by the manufacturer may cause unsafe conditions or reduce performance. 

8.

 

Visually inspect the system prior to installation. If the quartz sleeve or lamp is broken, cracked or damaged in anyway, 

DO NOT use. 

9.

 

DO NOT plug the system into an electrical outlet without properly securing the lamp and quartz sleeve into the chamber. 

10.

 

Always shut off water flow and release water pressure before cleaning and maintaining the system. 

11.

 

Intended for indoor use only.  System MUST NOT be exposed to weather elements. 

12.

 

Installation of the system MUST be in accordance with local plumbing and electrical codes as well as any and all 

applicable regulations and laws. 

13.

 

Warranty will be VOID if the above is not followed. 

14.

 

SAVE THIS MANUAL 

 

Summary of Contents for AQUA PRO 1 GPM
















Reviews: