11
3.3 Installation layout
3.4
Installing the unit
While operating, the heat pump is subject to condensation. This will result in a more or less large run-off of
water, depending on the degree of humidity.
Install the heat pump, raising it at least 10 cm with solid water-resistant pads, then connect the drainage pipe to
the opening located under the pump.
*IN Winter USE*
-
DO NOT Connect the
drainage pipe when using the heat pump in the
winter
, as this will allow the
water to freeze and block the tube. This will then allow water and ice to back up into the unit and cause damage which
will not be covered under the
Warranty
.
Please
allow unrestricted run off of the condensate from the unit and to escape freely.
3.5 Installing the unit on noise-damping supports
In order to minimize the noise pollution associated with heat pump vibrations, it can be positioned on vibration
absorbing pads.
To do this, you simply have to position a pad between each of the unit’s feet and its support, and then fix
the heat pump to the support with suitable screws.