Assembly Instructions
Assembly step 4
Bolt
NUT
#36 Carriage Bolt(M8*45MM)
[4 pieces]
#37 Bolt (M8*35MM)
[2 pieces]
#41 Bolt (M5*10MM)
[4 pieces]
Washer
#47 Arc Washer (M8)
[4 pieces]
#51 Washer (M8)
[2 pieces]
Hardware Required
#43 Nut (M8)
[4 pieces]
#52 Spring Washer (M8)
[6 pieces]
A.) Handle Bar Assembly
Insert the Right Handle Bar(#10) into the opening at the end of the Right Coupler
Bar(#05)and secure it by inserting two Carriage Bolts(#36)and fastening with two
Arc Washers(#47),two Spring Washers(#52)and two Nuts(#43).
Repeat this process on the left side using Left Handle Bar(#09)and Left Coupler
Bar(#04).
B.) Pulse Handle Bar Assembly
Align and attach the Pulse Handle Bar(#11)to the bracket on the Center Post(#03).
Secure together using two Bolts(#37)through two Spring Washers(#52)and two
Washers(#51)as illustrated.
Monitor Assembly
Remove the four Bolts(#41)that are pre-assembled on the Monitor(#12)and set them
aside nearby.Connect the Monitor Wire (Upper)(#21)to the Monitor Wire
(Middle)(#20). Secure the Monitor(#12)to the bracket of the Center Post(#03)with
the four Bolts(#41)that were previously set aside.
Next, connect the Hand Pulse Cable(#22)by plugging it into the hole on the back
of the Monitor(#12).
SJ2508