Crystal Vision
Appendix 2
8 Appendix 2
Indigo Frame Software prior to v4.6
Prior to frame software version 4.6, Ethernet-enabled Indigo frames used an
entirely different web interface. The following is documented for users of older
frame software.
Setting up and connecting
The frame can be connected to a network port or directly to a PC from the rear
panel RJ45 port labelled Ethernet. If connecting directly to a PC, a CAT5 crossover
cable may be required. Connecting to a network port hub uses a straight CAT5
cable. To access the internal web page set the frame to the default IP address by
setting the default IP address switch DIP4 to down. Open up your PC web browser
and set its search to http://10.0.0.201 and select ‘go to’. This is the default IP
address, the sub-mask being 255.255.255.0. After a dialogue box has briefly
appeared the Indigo main status page will be displayed.
Indigo Status page
This page will give a large amount of status information about the frame and its
power supplies. From the web page several options are available such as changing
the IP address and frame naming.
Indigo DT User Manual R1.8
34
05 July 2018
