Note: to maintain sanitization of the system, refrain from touching the section of the bottle adaptor tube
that is inserted into the bottle
22. Slide bottle into cabinet and close the door (Figure 18 to Figure 20) (slide door downwards to close)
23. Depress the
and
water levers to fill their respective tanks.
Cold
Hot
21. Remove red protective cap from the blue tube of the Smartflo™ Water Cartridge and install onto the
bottle adaptor assembly (Figure 17)
TM
11. Ensure seal is properly installed on the outlet tube of the SmartFlo Water Cartridge assembly (may
have shifted during shipment or un-packaging)
20. Push the tube to go through the Spike Cap, until it is close/hits bottom of the bottle (Figure 16)
16. Place fresh bottle outside of the cabinet
14. Close the locking clip to secure water outlet tubing in place (Figure 12)
TM
12. Align SmartFlo Water Cartridge with openings in cooler, and push into place
TM
13. Rotate turn knobs to lock SmartFlo Water Cartridge in place (Figure 11)
15. Close the top cover of the cooler (Figure 13) (push downwards to lock into place)
17. Clean the outside of the new bottle with a cloth. Remove security label/seal from the bottle cap (if applicable)
18. Remove bottle adaptor assembly from the empty bottle (Figure 14), and set aside. Carefully un-package
the Bottle Adaptor assembly, avoiding touching the tube.
19. Without touching the tube, install the Spike Cap (with the end of the tube in the Spike Cap) (Figure 15)
24. When water begins to flow from both faucets, the tanks have been filled (approximately 1 minute per
tank)
CAUTION! ALWAYS DRAIN WATER COMPLETELY BEFORE SHIPPING OR STORING THE COOLER!
Figure 11
Figure 12 Figure 13
Figure 14 Figure 15 Figure 16 Figure 17
Figure 18 Figure 19 Figure 20