Grasp around the handset to unlock its functions. The green unlock light will illuminate
to show when the handset is unlocked and ready to accept commands. (N.B. Keep a grip
of handset to keep it unlocked, to continue to operate the command buttons.)
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
;
3
Power button – To start the fire, (after following the instructions of the previous page), with one hand grasp
around the rear of both sides of the button area control. The green unlock light will illuminate. Keep the
handset held to keep the control unlocked, to enable operation of the buttons. Then with the other hand
touch and hold a finger on the power button for about 3 seconds. (A short beep and a flash of the unlock
light will happen upon touching.) When the word “pilot” appears at the bottom left hand corner of the
display, immediately release the power button. (A second flash of the unlock light and a longer beep will also
sound at the time to release the power button). The Fire should be lit within a few seconds. ( N.B. If power
button is held for more than a few seconds after second flash/beep/word pilot appears, the command is
ignored for safety reasons. Similarly if it is released too soon before the word pilot appears, the command is
also ignored. With this system, the control has been designed to ensure that only intended ignition of the
fire occurs.)To stop – with handset held to unlock it, press then release power button.
Mode –
MAN( Manual), Zzz
(Snooze), thermostat or timed
.
Time (12hour or 24 hr
display)
In Range of fire
(missing if not in
range or if Fire
Control turned off)
Room Temperature
Handset Unlocked
when Illuminated
To change handset
settings
(see handbook)
Press to increase
"lame
Press to decrease flame
To change mode
(see handbook)
Light sensor
(for display back
light)
Battery condition –
RC handset, FC fire
control
Gas fire burner
status
Day of the week
