Be sure to choose the correct output terminals on your amplifier or receiver to properly
connect your BPS and BPT speakers (figure 3).
>
For front left and right speakers: use the front left and right speaker output terminals on
your amplifier or receiver and connect two BPS or BPT speakers
>
For centre speaker: use the centre channel speaker output terminals on your amplifier or
receiver to connect your BPS speaker
>
For surround (rear) speakers: use the two surround (rear) speaker output terminals on
your amplifier or receiver to connect two BPS or BPT speakers
5
Installation of TX-8SUB / TX-10SUB
5.1 Inputs
Your new subwoofer is equipped with line-level (RCA• Audio In) input for connection with a
pre-amp, signal processor or receiver with pre-amp level outputs. Some receivers may not
provide enough signal to have the unit’s Auto On/Off feature operate properly. Additionally
this lack of signal may cause the subwoofer to produce less output than it is capable of.
•
If using a receiver with LFE out, be sure the LFE channel is sending adequate signal to
the subwoofer. We recommend setting the subwoofer’s level to the 9 o’clock setting (1/4
volume setting) and then adjust the LFE channel on your receiver or processor to achieve
the desired bass output.
*See your receiver or processor’s owner manual for more information.
5.2 Volume Control
The volume control allows you to balance the output from the subwoofer to the main
speakers/amplifier in your system. This control should be set to achieve similar output
levels from both the main speakers and subwoofer when listening to music. A good
starting point for the volume control is two or three levels above minimum.
13
