Crypto URC-601A, User Manual

Page: 6 / 45

URC-601A User Manual/Εγχειρίδιο Χρήσης
5
2.1.3 Automatic code search programming
1. Turn on your TV you want to program to work
with the Crypto URC-601A remote control. Hold
the remote in a straight line in front of your TV at
a distance less than 1 meter.
2. Press and hold down the remote device mode
button and button at the same time
until the red light indicator lights up constantly.
3. Press the POWER button
4. The button will blink continuously in red
meaning that the remote is searching for the
code of your TV.
5. When the remote finds your TV code the TV
will turn off.
Attention: When the TV turns off you must
immediately press the button to avoid the
remote to go to the next code.
6. By pressing the button you have
already stored the code. The button light
will turn off.
Note: This automatic search can be finished without finding an appropriate code for
your TV.In that case the button will stop blinking and your TV will remain on.
Given the size of the code libraries in the remote control, it will take several minutes
to cycle through all the codes
Actions to verify correct programming
Once you have stored on the remote the correct code, check to see if most of the
buttons are working according to the functions of your TV.
Corrective Actions
If any of the buttons do not work properly, you can program those buttons individually
by using the learning function process described in chapter 3.