CRX321
INTELLIGENT BATTERY CHARGER
Instruction manual
Original manual
NOTE!
Read this instruction manual carefully before using the unit and follow all given instructions.
Save the instructions for further reference.
TECHNICAL SPECIFICATION
Suitable for 6V and 12V Normal Lead Acid, Sealed, Leisure and Gel Batteries between 5-120Ah.
Input:
220V – 240V ~ 50Hz Max. 75W
Output:
7.2V, 1A DC (1.5A RMS)
14.4V, 1A DC (1.5A RMS)
14.4V, 4A DC (6A RMS)
14.7V, 4A DC (6A RMS)
13.8V, 4A DC (6A RMS)
IMPORTANT SAFETY INSTRUCTIONS
Please carefully read and follow the following safety and operating instructions.
Gases
When the battery is being charged you may notice bubbling in the fluid caused by the release of gas. As the gas is
flammable no naked lights should be used around the battery, and the area should be kept well ventilated. Because
of this risk of explosive gas only connect and disconnect the battery leads when the mains supply is disconnected.
Type of batteries
This charger is only suitable for normal lead acid, sealed, leisure or gel batteries and should not be used to recharge
NICAD or any other type of battery.
Points of note
•
When not in use, store the charger in a dry area to avoid moisture damaging the transformer.
•
This battery charger is not designed as power supply.
Repair
•
The Battery Charger should not be opened. Any attempt at modification or repair by the user will entail the
loss of your guarantee.
•
The mains supply cord of this appliance cannot be replaced; if the cord is damaged, the appliance has to be
discarded.
Danger!
•
Avoid getting electrolyte on your skin or clothes. It is acidic and can cause burns. If this occurs you should
rinse the affected area with water immediately.
•
If it gets into your eyes - wash thoroughly and seek medical attention immediately.
•
Never charge a frozen battery. If battery fluid frozen, bring battery into a warm place and let it thaw before
you begin charging. Never place a battery on top of charger or vice versa.
•
Do not touch the battery clamps together when the charger is on.
•
Never operate charger if it has received a hard blow, been dropped, or otherwise damaged. Take it to a
qualified professional for inspection and repair.
•
Be sure to position the charger power cord to prevent it from being stepped on, tripped over, or damaged.
EN
