Page 5
Page 7
Page 10
Figure 1
Installation
Before starting the installation, please read this
entire section first. Be sure to install the bulkhead
gasket before you install the instrument. Finger
tighten the screws that mount the instrument bracket
- do not use tools.
Page 12
driver to make the connections to the screw terminal
on the instrument case back as shown in figure 2.
l
Carefully check all your wiring against those
shown in figure 2. If everything is wired correctly
you can mount the PR60 in the instrument hole. Be sure
the bulkhead gasket is in place and use only finger
tension to tighten the bracket hold-down nuts
Do not
overtighten the bracket or you may damage the case
-
do not use tools to tighten the nuts.
Displaying Pressure
Press the
:
key to display pressure (PSI or Bars).
Press the
s
key to display pressure in percent (0 to
100%).
Setting Maximum Pressure Range
Press and hold down the
:
key for 10 seconds (until
you hear a long beep.) Use the
t
and
s
keys to set
the maximum pressure for your pressure sender, either
in PSI or Bars. Once the maximum pressure is showing
on the display, press the
:
key for 1/2 second to save
this value into memory.
Bulkhead
Gasket
2-1/8" (55mm) hole
Mounting
Bracket
Finger tighten only - Do not use tools
