INTERFACING SOLUTIONS
VIMGM-94M
VIDEO IN-MOTION INTEGRATION
FOR SELECT CHEVROLET, CADILLAC
& GMC VEHICLES 2013-UP
www.cruxinterfacing.com
Rev. 091814
5
CONNECTING YOUR DEVICES TO THE INTERFACE
Follow these steps to properly install the interface module.
Step 5
-The power for the module can be found on the GREEN 16-PIN connector. Located next to the GRAY connector.
RED
= 12V CONSTANT / BLACK = GROUND (Make sure to measure the wires with a volt meter to confirm)
Step 6
- Connect the 8-Pin connector to the module and set your dip switch number 1 to ON. If the vehicle has a factory rear-view camera
Please set dip switch number 2 to ON also, if not simply leave OFF.
DIP SWITCH DESCRIPTION
IF NOT USING THE INPUT, PLACE TO OFF
DIP 1 = Video In-Motion Enable
DIP 2 = Not Used
DIP 3 = Not Used
DIP 4 = Not Used
DIP 5 = Not Used
DIP 6 = Not Used
After each change of the DIP switch settings,
we recommend powering down the module,
then restarting the vehicle.
DOES NOT EFFECT THE FACTORY
REAR-VIEW CAMERA.
LED INDICATORS
BLUE LED:
ON = Power On
OFF = Power OFF
UP=ON
DOWN=OFF
