Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, C
A
91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.020320
SWRTY-61N
Radio Replacement with Steering Wheel Retention and
Rear-View Camera Retention for TOYOTA Vehicles
1 of 3
RADIO REPLACEMENT
SWC RETENTION
+
R
INTERFACING SOLUTIONS
- Retains factory features in select Toyota vehicles while functioning with an aftermarket radio.
- Pre-programmed to retain factory Steering Wheel Controls.
- iPhone Voice Recognition (VR) feature from SWC on select radios.
- Retains OEM Rear View Camera.
- Retains factory USB and auxiliary audio input (aftermarket radio must have these features).
- Includes factory USB retention adapter cable.
- Supports BT-HF/A2DP/AVRCP profile on select aftermarket radio models.
- Supports Pick Up/End Call, Pick up and Toggle between 1st and 2nd incoming call, AVRCP Track, Seek.
- EIA color coded wiring for easy installation.
PRODUCT FEATURES:
PARTS INCLUDED:
INSTALLATION DIAGRAM:
SWRTY-61N MODULE
SWRTY-61N HARNESS
USB Retention Cable
SWC CABLE
AFTERMARKET
RADIO
SWRTY-61N
MODULE
+12V Constant Yellow
+12V ACC Red
Ground Black
Illumination Orange
Not Used
Blue/ White
Right Front (+) Gray
Right Front (-) Gray/Black
Left Front (+) White
Left Front (-) White/Black
Right Rear (+) Violet
Right Rear (-) Violet/Black
Left Rear (+) Green
Left Rear (-) Green/Black
Vehicle Speed Sense (VSS) Red/Black
Reverse Trigger Red/White
Parking Brake
(see special note below)
Yellow/Black
Power Antenna Blue
Audio Input
Red/White RCA
(Retains Factory AUX Input
in Select 2007-Up Vehicles)
TO FACTORY
HARNESS
12-Pin Black
Connector
28 PIN
10 PIN
6 PIN
USB-TY01
USB Retention Adaptor
(included in kit)
Blue / Antenna Turn On
ANTENNA ADAPTOR
(Included in Kit)
Blue / Antenna Turn On
NOTE:
The BLUE Antenna Turn-On wire
should ONLY be connected to
one circuit of the aftermarket
radio. Choose the one which has
a wire populated on the factory
connector side.
24 PIN
Yellow RCA
(Retain OE Camera)
Rear View Camera Signal
ON R
ADIO
VEHICLE
1 2 3 4 5 6 7 8
AFTERMARKET
RADIO SELECTOR
(See Chart)
TOYOTA
SWC SETTING
(OFF ON OFF ON)
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
Cap or insulate if
not being used
Kenwood/JVC (BLUE / YELLOW)
Insulate with tape
if not being used
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS” section.
To aftermarket
radio SWC port
