background image

Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA  91311

phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com

rev.110419

SOOGM-19L

OnStar Radio Replacement Interface with Steering Wheel 

Control Retention for GM LAN v2 (LIN) Bus Vehicles 2014 - 2018

2 of 4

RADIO REPLACEMENT

SWC RETENTION

+

R

INTERFACING SOLUTIONS

Plug in the 8-pin Molex connector of the SOOGM-19L harness 

to the Black, NON BOSE, port of the module. 

Non-Bose

Port

The SOOGM-19L has a potentiometer to adjust the chime 

volume.  It is set at half way by default. To adjust the volume, 

simply use a suitable screw driver and turn the potentiometer 

clockwise to increase the volume and counter-clockwise to 

decrease the volume.

Chime

Volume

Adjustment

CHIME VOLUME ADJUSTMENT:

ONSTAR VOLUME ADJUSTMENT:

To adjust the OnStar volume, turn on OnStar and adjust the volume using the SWC volume adjustment. There 

are 4 steps of volume control. Once it is set, the SOOGM-19L will memorize this level.

AUDIO  CONNECTION:

BOSE AMPLIFIER BYPASS:

For vehicles equipped with a factory Bose amplifier, extend the speaker wires of the SOOGM-19L harness and 

connect to the Bose amplifier output wires. Locate the Bose amplifier to find out how much speaker wires is 

neccessary. The Bose amplifier is located as follows: 

(NOTE: Bose amplifiers are commonly found in the locations listed 

below but the manufacturer can mount it elsewhere. Installer should verify the location before installation.)

Trucks = Center of the rear wall     /     SUVs = Center console or in the cargo space     /     Sedans = Rear deck or Trunk area

Pinout for the 8 and 16 pin OEM Bose amplifier connectors:

1

4
8

5

1

8

9

16

Pin #

Wire Color

Descrip�on

1

Dark Blue / Grey

Sub

2

Yellow

Right Front S

3

Dark Blue

Le� Front S

4

Red / Yellow

Co12V

5

Grey / Black

Subwoofer -

6

Yellow / Black

Right Front Speaker -

7

Brown / Dark Blue

Le� Front Speaker -

8

Black

Ground

Pin #

Wire Color

Descrip�on

4

Brown / Light Green

Right Front T

5

Yellow / Dark Blue

Le� Front

 T

6

White

Right Rear S

7

Light Green

Le� Rear S

12

Purple / Brown

Right Front Tweeter - 

13

Yellow / Grey

Le� Front

 Tweeter - 

14

Dark Blue / Black

Right Rear Speaker -

15

Light Green / Black

Le� Rear Speaker -

Summary of Contents for SOOGM-19L

Page 1: ...SOOGM 19L MODULE SOOGM 19L HARNESS SWC CABLE ANTENNA ADAPTER SOOGM 19L OnStar Radio Replacement Interface with Steering Wheel Control Retention for GM LAN v2 LIN Bus Vehicles 2014 2018 AFTERMARKET RADIO Reverse Red White Illumina on Orange 12V Constant Yellow 12V ACC Red Ground Black Entertainment Turn On Blue White Parking Brake Yellow Black Vehicle Speed Sense Purple White Right Front Gray Right...

Page 2: ...E AMPLIFIER BYPASS For vehicles equipped with a factory Bose amplifier extend the speaker wires of the SOOGM 19L harness and connect to the Bose amplifier output wires Locate the Bose amplifier to find out how much speaker wires is neccessary The Bose amplifier is located as follows NOTE Bose amplifiers are commonly found in the locations listed below but the manufacturer can mount it elsewhere In...

Page 3: ...hime and Retained Accessory Power RAP functions Reverse the process to install the new aftermarket radio The SOOGM 19L is prewired with an RCA connector to retain the OEM camera on vehicles with a IO3 system To retain the OEM camera on IO4 IO5 and IO6 systems you will need connect an RCA cable to the 12 pin connector on the HMI module found either by the passenger kick panel or behind the glove bo...

Page 4: ... ON ON OFF OFF ON ON OFF OFF OFF OFF ON ON OFF OFF ON ON ON OFF ON OFF ON OFF ON OFF OFF OFF OFF ON OFF OFF NOTE For Blaupunkt Dual Farenheit Power Acoustik Soundstream and most off brand radios check the aftermarket radio s manual to see if the SWC buttons need to be programmed SWC MODULE DIP SWITCH 1 2 3 4 ON BUICK 2015 2016 ENCORE 2017 ENVISION 2016 LACROSSE 2014 2015 REGAL CADILLAC 2015 2016 A...

Reviews: