Crux Interfacing Solutions • 6860 Canby Ave., Suite 104, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.111218
2 of 3
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
DIP SWITCH SETTINGS:
INSTALLATION INSTRUCTIONS:
INSTALLING THE INTEFACE MODULE
1. Carefully remove the radio to gain access to the radio harness.
2. Unplug the radio connector and plug it into the female connector of the VRFCH-75U T-harness.
3. Plug in the T-harness (10-pin Molex connector), Video and Audio harnesses to the VRFCH-75U module.
4. Install the front camera (not included) following the manufacturer’s instructions.
5. After installation of the front camera, plug in the camera’s video RCA to the female RCA (Front Camera) and connect the
camera power to the BLUE wire (Front Camera Power 12V) of the VRFCH-75U harness.
6. Plug in any other Audio/Video devices to be installed to the AV inputs of the VRFCH-75U.
7. Connect the AUDIO IN and AUDIO OUT on the VRFCH-75U harness. See diagram on page 1.
8. Connect the DIF. Video IN and DIF. Video OUT connectors. See diagram on page 1.
9. Set the DIP switches on the VRFCH-75U module following the chart above.
10. Connect the ACC, 12V Constant and Ground wires of the VRFCH-75U to the vehicle power. See diagram on page 1.
SETTING
DIP 1
DIP2
DIP3
DIP4
DIP5
DIP6
DIP7
DIP8
ON
AV 1 Enabled AV 2 Enabled
Front Camera
Enabled
Set to OFF
Set to OFF
Manual
Transmission
Brightness
Set to ON*
Set to ON
OFF
AV 1 Disabled AV 2 Disabled Front Camera
Disabled
Set to OFF
Set to OFF
Automatic
Transmission
The interface module is installed behind the headunit.
VRFCH-75U
Rear & Front View Integration Interface
for Chrysler, Dodge, Jeep & RAM Vehicles with Uconnect
*
We recommend setting DIP #7 to ON, however, if the video does not display correctly, set DIP #7 to OFF instead.
OPERATION:
1. Putting the gear in REVERSE automatically shows the rear
camera onto the display.
2. If a front camera is installed, the VRFCH-75U automatically shows the front camera for
10 seconds or until the vehicle reaches a speed of 10 MPH after a reverse process.
P
R
N
D
_
+
P
R
N
D
_
+
