background image

8-PIN

(male plug)

4      5      6

ON

1      2      3

TO FACTORY

HARNESS

VOLUME

TUNE

52-PIN

(male plug)

TO FACTORY

DISPLAY

52-PIN

(female plug)

4      5      6

TO ENABLE VIDEO

IN-MOTION

1. On = Enable VIM

2. Not Used

3. Not Used

4. Not Used

5. Not Used

6. Not Used

ON

1      2      3

SAFETY WARNING:

THIS INTERFACE IS DESIGNED TO ACTIVATE

VIDEO IN-MOTION TO ALLOW THE PASSENER

ACCESS TO THE ADDRESS INPUT WHILE THE

VEHICLE IS IN-MOTION. THIS INTERFACE MAY

CAUSE AN ERROR WHEN SERVICED AT THE OEM 

DEALER. BE AWARE THAT MOST DEALERS

WILL ATTEMPT TO VOID THE MANUFACTURERS

WARANTY WHEN INSTALLING ANY AFTERMARKET 

EQUIPMENT. IMPROPER USE OF THIS INTERFACE 

BY THE DRIVER MAY RESULT IN CITATION. DRIVER 

MUST KEEP FULL ATTENTION ON THE ROAD AND 

RESPOSIBILITY ON THE SAFETY OF HIS 

PASSENGERS.

INTERFACING SOLUTIONS

VIDEO IN-MOTION FOR DODGE & JEEP VEHICLES 2013-UP

DODGE:

2013 - 2014  Ram

JEEP:

2014 -2014  Grand Cherokee

IMPORTANT:

Compatible Nav Radio Type: 

U-CONNECT 8.4” SCREEN (1-Piece)

VIMCF-93C

We recommend reading this installation guide first before starting any 

work.  Following these instructions from “Start” to” Finish” will ensure 

a smooth and hassle free installation. We offer telephone support M-F 

9:00 AM – 5:00PM PDT at 1 (855) 822-1348. We are here to help.

PARTS INCLUDED:

(1) CF-93C Interface

(1) CF-93C T-Harness

(1) Instruction

PRECAUTIONS:

- Remove the negative side of the battery to avoid any short circuits

   durring the installation.

- Do not install the interface near any major components or near the

   HVAC system. This may cause damage or overheating to the vehicle.
- Do not disconnect the airbag connection behind the radio panel.

PRELIMINARY

:

Please read the entire mannual before installing this interface.

INSTALLATION OVERVIEW

TROUBLE SHOOTING

1. No video display while driving.

   - Make sure the dip swithces are in the proper location.

Rev. 110413

INSTALLING THE INTERFACE:

1. Remove the factory display to gain access to the factory connectors.

2. Remove the 52-Pin connector from behind the display.

2. Make the T-Harness connections behind the factory display.

    (if the connectors do not match please contact tech support)

4. Set dip switch “1” to permanently activate the VIM feature.

5. Test the Navigation address input while the car is in-motion to verify

    the VIM is active.

SETTING THE DIP SWITCHES

8-PIN

(male plug)

4      5      6

ON

1      2      3

TO FACTORY

HARNESS

VOLUME

TUNE

52-PIN

(male plug)

TO FACTORY

DISPLAY

52-PIN

(female plug)

4      5      6

TO ENABLE VIDEO

IN-MOTION

1. On = Enable VIM

2. Not Used

3. Not Used

4. Not Used

5. Not Used

6. Not Used

ON

1      2      3

8.4”

DISPLAYS

Reviews: