Crux Interfacing Solutions • Chatsworth, C
A 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www
.cruxinterfacing.com
rev.020521
2 of 3
R
INTERFACING SOLUTIONS
Sightline
Multi View Integration
RVCVW-73
Rear View Integration Interface for Select
Volkswagen Vehicles with MFD3/RNS315/RNS510 Navigation System
INSTALLATION INSTRUCTIONS:
CODING THE RADIO FOR A BACKUP CAMERA
1. Locate the vehicle’s OBD II port usually located under the steering column.
2. Enter the vehicle and CLOSE ALL DOORS.
3. Turn the key to the ON position.
4. Plug in the OBD coder from the RVCVW-73 kit to the ODB II port.
5. Wait for the OBD coder to finish coding the radio and give a solid GREEN LED. (See chart below)
6. The radio may flash a few time during this process. It can take around 5 seconds to complete the
coding process. If an error occurs, retry the coding procedure.
7. A solid RED LED means that the radio has been decoded. Repeat the process to get a solid GREEN LED.
8. After the coding is complete, disconnet the OBD coder and store in a safe place. This OBD coder is VIN
specific and will only work on this vehicle.
9. Unplug the radio power connector for 5 seconds and plug it back in.
10. Put the gear in reverse to test for camera functionality.
In order for the vehicle to recognize the camera and engage it when in reverse gear, the vehicle must be
coded. Use the ODB II coder included in the RVCVW-73 kit.
Reading the LED color pattern:
Flashing LED
Coding Vehicle
Solid Green LED
Activated
Solid Red LED
Deactivated
Solid Red & Green LED
Error
INTERFACE
GREEN LED
RED LED
8-PIN
(male plug)
LED
(indicator)
OBD CODER
DECODING THE RADIO
To decode the radio, repeat the steps above.
