8
Assembly instructions
Warning:
Always make sure the juice extractor is unplugged
before starting assembly.
Important:
The juice extractor is equipped with a safety
system that prevents the extractor from being turned on
unless the unit is completely and properly assembled.
1. Rotate the locking bar so that it sits at the front of the
base (see figure 2).
2. Place the juice bowl on top of the motor base so that
the juice spout fits into the cut out at the front of the base
(see figure 3).
Caution:
Use care when handling the stainless steel blade
basket. Hold the basket’s rim only. Do not touch the cutter
blades on the bottom of the basket. The cutter blades are
very sharp!
3. Set the stainless steel blade basket onto the motor hub
in the center of the juice bowl (see figure 3). Press down
on the blade basket’s outer rim until it drops into place
and is securely seated. Gently rotate the blade basket
to ensure that it turns freely. If initially it fails to seat,
this should slip it into place. Double check by pressing
down on the rim and spinning it again.
4. Align the cover so that the pulp cover fits over the back
of the base. (see figure 4).
5. Turn the food pusher so that the groove in the side lines
up with the tab in the feed tube. Insert the food pusher
into the feed tube (see figure 5). Store the food pusher
in the feed tube of the lid until the produce is ready to
juice.
Figure 2
Figure 3
Figure 4
Locking
bar
Tab
Groove
Figure 5
Summary of Contents for 14809
Page 25: ......