Rugged, Reliable, Mobile, Secure
TM
1-800-260-9800
www.CRU-DataPort.com
DataPort 2 and 4 Bay Enclosure
Install Guide
The DataPort 2 & 4 Bay Enclosures include the following pieces.
If any items are missing or damaged please contact CRU for a
replacement.
4 Bay Enclosure Package Contents
1 - External Enclosure
1 - U320 LVD Terminator
1 - External U320 VHD to UVHD Cable
4 - Hard Drive Mounting Rails
1 - Installation Guide
2 Bay Enclosure Package Contents
1 - External Enclosure
1 - U320 LVD Terminator
1 - External U320 VHD to UVHD Cable
2 - Hard Drive Mounting Rails
1 - Installation Guide
Enclosure Set Up
1. Remove the cover of the DataPort Enclosure. Remove the rear
screws and slide the cover off the back of the enclosure.
2. Remove the front bezels if you are installing a device that
needs external access such as a tape back up unit or CD-ROM.
The DataPort 2 and 4 Bay SCSI Enclosures allow external SCSI devices to be easily
added to any system with an available external SCSI channel. The DataPort Enclo-
sures can provide additional tape backup units, CD-ROMs or non-removable hard
drives to a server. The DataPort 2 and 4 Bay Enclosures will support most full height
SCSI tape backup units. For adding removable DataPort hard drives please contact
CRU at www.CRU-DataPort.com.
3. Set the SCSI ID on the device or remove the jumpers and use
the provided SCSI ID selector switch. Do not use SCSI ID #7, it
is used by SCSI Host Bus Adapters.
4. Install the hard drive mounting kits and secure them with the
provided screws. Otherwise install the SCSI device into the
enclosure and secure them with the provided screws.
5. Connect the data and power cables to the back of the SCSI
devices. If needed connect the SCSI ID selector switches.
6. Slide the cover back on and secure it with the screws.
7. Connect the external power cable, the SCSI cable and
Terminator.
Your enclosure is now setup and ready for use.
