Assembly Instructions
Lay out all components so they are all clearly identifiable prior to assembly.
Remove excess adhesive with a damp cloth before it dries.
Support the door during assembly and do not allow the door to fall open, as this will damage the hinge.
Product Care
To retain the best quality finish, clean product regularly with a soft cloth and mild detergents. Do not use abrasive or chemical
cleaners, as these will damage the product.
Do not slam the door open against its mechanical limits, as this will damage the hinge.
For details of other items in the Croydex range please visit our website:
Croydex Limited, Central Way, Andover, Hants, SP10 5AW, UK
CAB 022 R06
2. Secure side panel to base panel
using two fixing screws. (Screws
mounted from underside of base. To
improve strength place small amount
of glue on underside of side panel
before securing into position.)
6. Place one of the door pivot pins
into the hole recess situated on the
base. (Hinge grommets need to be
located in the recess of the top and
base panels before inserting the
pivot pin.) Locate mirrored door onto
pivot pin and place the remaining
pivot pin into the top of the door
before securing the top panel.
7. Place top panel onto cabinet
carcase ensuring all screw holes,
recesses, hinge grommets and
dowels are accurately aligned with
assembled cabinet. Secure top
panel to both side panels with the
four remaining fixing screws.
Important: Please allow the glue
to dry prior to fitting the cabinet.
9. Insert shelf supports into hole
recesses and ensure all supports
are aligned accurately. Place the
shelf in the cabinet and lower onto
the shelf supports. (Door not shown)
8. Hold the cabinet against the wall in its
desired location and check that it is straight
and level. Open the door(s) and mark the wall
using the holes in the back of the cabinet as a
guide. Drill 40mm deep holes in marked
positions using a 6mm masonry drill and insert
wall plugs. Align the holes in the back of the
cabinet with the wall plugs. Insert the screws
through the washers and holes in the back of
the cabinet and screw in position.
1. Mount the magnetic door catch onto
the top panel. Use all four magnetic
catch screws. Door catch must be fitted
to opposite side of door hinge. (The
magnetic door plate must be secured
to the back face of the mirrored door to
ensure that the catch works correctly)
3. Place two wooden dowels into
each end of the strengthening
baton. Align the dowels and locate
into side panel. (Wooden dowels
must be glued into position.)
4. Place the second side panel onto the
wooden dowels protruding from the
strengthening baton and secure side
panel to base panel using two fixing
screws. (To improve strength place small
amount of glue on underside of side panel
before securing into position. Mount
screws from underside of base.) Slide the
backing board into the two recesses
evident on the two sidewalls. Locate into
the base panel.
5. Place one wooden dowel into
the top of the hanging baton.
(Wooden dowel must be glued into
position.)
