fig. 5
fig. 3
Pointed Arrow
fig. 2
CAB 150 R01
3
SECTION 2 - CABINET ASSEMBLY
TOOLS REQUIRED
1.
Screw in four locking cam pins (B) into
both side panels (H) in the holes indicated
below using a cross head screwdriver.
DO NOT OVERTIGHTEN!
(See Fig. 1)
fig. 1
dowel holes
3.
Insert four cam locks (A) into both top/
bottom panels (I). Ensure the pointed arrow
is facing the ends of the panel as shown.
DO NOT OVERTIGHTEN!
(See Fig. 3)
2.
Insert four wooden dowels (C) into both
side panels (H) in the holes indicated below.
DO NOT USE A HAMMER TO INSERT THE
DOWELS!
(See Fig. 2)
4.
Select one top/bottom panel (I) to be
your bottom panel and lay it down flat.
Select one side panel (H) to be your left
side panel and locate it onto the dowels/
locking cam pins. Ensure that the grooves
in both panels are located towards the rear
of the cabinet. Once seated rotate the cam
locks (A) through 90° clockwise to secure in
place.
DO NOT OVERTIGHTEN!
(See Fig. 4)
5.
Insert back panel (J) ensuring it sits in the
grooves properly.
IMPORTANT:
Ensure the back panel is
facing the correct direction. The larger face
should be facing the front of the cabinet.
(See Fig. 5)
fig. 4
locking cam pin holes
Grooves
This surface
should face
the front!
