3
4
electrical failure or accident of motor and switch.
Ⅳ
.Steps of using
1
blending part
1 Put the machine on a stable table.
2 Screw on the cross-knife base at the bottom of the juice cup.
3.Firstly adding an appropriate amount of purified water in the juice cup, then
put the vegetables and fruits which have been cut into small pieces in the juice
cup, pay attention that the whole mixed volume cannot exceed the maximum
scale-line position of the cup.
1 Put the cover and lid onto the blending cup, then tighten it clockwise.
2 Plug in the machine into 120 voltage and make sure the indication light is red.
6.Put the blending cup on the main body and be sure the upper concave parts fix
well to the convex parts on the bottom of the cup, then tighten it clockwise.
7.Press the switch and be sure the indication light is blue, at that time the
machine runs normally.
2
soy-bean milk making
1.Dip the soybean into the water for 8 hours
2.Insert the filter down the center of the cup, making sure to line the three
notches up with the three ribs inside of the blending cup.
3.Twist the cross blade onto the bottom of blending cup.
2 Add some water in the blending cup and waterlogged beans in the lid. Measure
the beans by lid, and never add beans more than one and half cups. After it , fix
the lid on the cover of the cup.
3 Plug in and press down the switch. When the machine works regularly, it can
finish the soybean milk making in 1 minutes.
6.Pour out the soybean milk and the residue left in the filter naturally.
7.Boil the pre-processed soybean milk, then it can be drink directly.
(
3
)
grinding
1.Put the food in the low cup, making sure it does not exceed 100g.
2. Twist the flat blade on the bottom of low cup and fix it on the main body.
3.Plug in the machine. Generally, it can finish grinding in 30 seconds.
4.Unplug the machine once it finishes grinding, then twist off the blade and pour
out
the food.
Ⅴ
.clean and maintain
1.In case of electric shock, you must be sure the machine is power off when
cleaning the body,
2.Clean the main body by wet close instead of water.
3.Do not wash the products by dish washer.
4.It can be used again once you clean up the parts and assemble them well.
5.The machine should be used often, otherwise place it in the dry and ventilated
environment.
