Crown CT13428, Original Instructions Manual

Page: 5 / 54

fire and/or serious injury.
b)Operations such as sanding, wire brushing or polishing are not
recommended to be performed with this power tool.
Operations for which the
power tool was not designed may create a hazard and caused personal injury.
c)Do not use accessories which are not specifically designed and
recommended by the tool manufacturer.
Just because the accessory can be
attached to your power tool, it does not assure safe operation.
d)The rated speed of the accessory must be at least equal to the maximum
speed marked on the power tool.
Accessories running faster than their rated speed
can break and fly apart.
e)The outside diameter and the thickness of your accessory must be within the
capacity rating of your power tool.
Incorrectly sized accessories cannot be
adequately guarded or controlled
．
f)The arbour size of wheels, flanges, backing pads or any other accessory must
properly fit the spindle of the power tool
．
Accessories with arbour holes that do not
match the mounting hardware of the power tool will run out of balance, vibrate
excessively and may cause loss of control.
g)Do not use a damaged accessory. Before each use inspect the accessory
such as abrasive wheels for chips and cracks. backing pad for cracks
，
tear or
excess wear, wire brush for loose or cracked wires. If power tool or accessory
is dropped, inspect for damage or install an undamaged accessory
．
After
inspecting and installing an accessory. position yourself and bystanders away
from the plane of the rotating accessory and run the power tool at maximum
no-load speed for one minute.
Damaged accessories will normally break apart
during this test time.
h)Wear personal protective equipment. Depending on application,use face
shield, safety goggles or safety glasses. As appropriate wear dust mask,
hearing protectors, gloves and workshop apron capable of stopping small
abrasive or workpiece fragments.
The eye protection must be capable of stopping
flying debris generated by various operations. The dust mask or respirator must be
capable of filtrating particles generated by your operation. Prolonged exposure to high
intensity noise may cause hearing loss.
i)Keep bystanders a safe distance away from work area
．
Anyone entering the
work area must wear personal protective equipment. Fragments of workpiece or
of a broken accessory may fly away and cause injury beyond immediate area of
operation.
j)Hold the power tool by insulated gripping surfaces only when performing an
operation where the cutting accessory may contact hidden wiring or its own
cord.
Cutting accessory contacting a “live” wire may make exposed metal parts of the
power tool “live” and could give the operator an electric shock.
k)Position the cord clear of the spinning accessory. If you lose control
，
the cord
may be cut or snagged and your hand or arm may be pulled into the spinning
accessory.
l)Never lay the power tool down until the accessory has come to a complete
stop
. The spinning accessory may grab the surface and pull the power tool out of your
control.