Crown Com-Tech 1600 Page 8 Service Manual Download

Page: 8 / 46

Com-Tech 1600 Amplifier Service Manual

Theory

Error Amp, called the Error Signal (ES) drives the
Voltage Translators.

Voltage Amplification

The Voltage Translator stage separates the output of
the Error Amp into balanced positive and negative
drive voltages for the Last Voltage Amplifiers (LVAs),
translating the signal from ground referenced ±15V to
±Vcc reference. LVAs provide the main voltage ampli-
fication and drive the High Side output stages. Gain
from Voltage Translator input to amplifier output is a
factor of 25.2.

Voltage Translators

A voltage divider network splits the Error Signal (ES)
into positive and negative drive signals for the bal-
anced voltage translator stage. These offset reference
voltages drive the input to the Voltage Translator
transistors. A nested NFb loop from the output of the
amplifier mixes with the inverted signal riding on the
offset references. This negative feedback fixes gain at
the offset reference points (and the output of the Error
Amp) at a factor of -25.2 with respect to the amplifier
output. The Voltage Translators are arranged in a
common base configuration for non-inverting voltage
gain with equal gain. They shift the audio from the
±15V reference to VCC reference. Their outputs drive
their respective LVA.

Also tied into the Voltage Translator inputs are ODEP
limiting transistors and control/protection transistors.
The ODEP transistors steal drive as dictated by the
ODEP circuitry (discussed later). The control/protec-
tion transistors act as switches to totally shunt audio to
ground during the turn-on delay, or during a DC/LF or

Fault protective action.

Last Voltage Amplifiers (LVAs)

The Voltage Translator stage channels the signal to
the Last Voltage Amplifiers (LVA's) in a balanced
configuration. The +LVA and -LVA, with their push-pull
effect through the Bias Servo, drive the fully comple-
mentary output stage. The LVAs are configured as
common emitter amplifiers. This configuration pro-
vides sufficient voltage gain and inverts the audio. The
polarity inversion is necessary to avoid an overall
polarity inversion from input jack to output jack, and it
allows the NFb loop to control Error Amp gain by
feeding back to its non-inverting input (with its polarity
opposite to the output of the VGS). With the added
voltage swing provided by the LVAs, the signal then
gains current amplification through the Darlington
emitter-follower output stage.

Grounded Bridge Topology

Figure 2 is a simplified example of the grounded
bridge output topology. It consists of four quadrants
of three deep Darlington (composite) emitter-follower
stages per channel: one NPN and one PNP on the
High Side of the bridge (driving the load), and one
NPN and one PNP on the Low Side of the bridge
(controlling the ground reference for the rails). The
output stages are biased to operate class AB+B for
ultra low distortion in the signal zero-crossing region
and high efficiency.

High Side (HS)

The High Side (HS) of the bridge operates much like
a conventional bipolar push-pull output configuration.

BGS

VGS

Error

Amp

Audio

Inputs

Voltage Divider

NFb Loop

ODEP

Mute