Crown International
1718 W. Mishawaka Rd.
Elkhart, IN 46517-9439
TEL:574-294-8200
FAX: 574-294-8FAX
www.crownaudio.com
8/07 139648-3
Crown’s Three-Year, No-Fault, Fully Transferable Warranty
Crown offers a Three-Year, No-Fault, Fully Transferable Warranty for every new Crown ampli-
fi er—an unsurpassed industry standard. With this unprecedented No-Fault protection, your new
Crown amplifi er is warranted to meet or exceed original specifi cations for the fi rst three years of
ownership. During this time, if your amplifi er fails, or does not perform to original specifi cations,
it will be repaired or replaced at our expense. About the only things not covered by this warranty
are those losses normally covered by insurance and those caused by intentional abuse. And the
coverage is transferable, should you sell your amplifi er.
See your authorized Crown dealer for full warranty disclosure and details. For customers outside
of the USA, please contact your authorized Crown distributor for warranty information or call
574-294-8200.
CDi Series
Signal Indicator:
Green LED, one per chan-
nel, illuminates when a very low-level signal is
present at input.
–10 Indicator:
Green LED fl ashes when output
signal exceeds –10 dB below clip.
–20 Indicator:
Green LED fl ashes when output
signal level exceeds –20 dB below clip.
Ready Indicator:
Green LED, one per chan-
nel, illuminates when the amplifi er is ready to
produce audio.
Clip Indicator:
Red LED, one per channel, turns
on at the threshold of audible distortion.
Temp Indicator:
Red LED, one per channel,
illuminates under excessive temperature
conditions.
Power Indicator:
Blue LED illuminates when
the amplifi er has been turned on and has
power.
Rear Panel Controls and Connectors
AC Line Connector:
NEMA 5-15P (15A).
Input Connector:
Two 3-pin removable
Phoenix-type connectors each accept a
balanced line-level input signal.
Output Connectors:
4-position barrier strip
with connectors for dual louspeakers or bridge-
mono loudspeaker. Dual connectors work with
2-8 ohm or 70V/100V loads. Bridge-mono con-
nectors work with 4-8 ohm or 140V loads.
HiQnet USB Connector:
Type B, connects to a
USB port on a PC.
Protection
CDi-Series amplifi ers are protected against
shorted, open or mismatched loads; overloaded
power supplies; excessive temperature; chain
destruction phenomena; excessive output
current, and input overload damage. They also
protect loudspeakers from input/output DC,
large or dangerous DC offsets and turn-on/
turn-off transients.
Included Accessories
Non-touch cover
Locking level-control knobs.
Construction
Chassis:
Steel.
Cooling:
Proportional speed fan with front-to-
rear airfl ow.
Dimensions:
EIA Standard 19-in. rack mount
width (EIA RS-310-B), 3.5 in. (8.9 cm) high and
12.25 in. (31.11 cm) deep behind mounting
surface.
Net Weight
:
19 lb (8.6 kg).
Shipping Weight:
22 lb (10.0 kg).
Specifi cations subject to change without prior notice. Latest
information available at www.crownaudio.com.
Crown, Crown Audio and Macro-Tech are registered
trademarks of Crown International. Other trademarks are the
property of their respective owners. ©2007 Crown Audio
®
,
Inc. Printed in U.S.A.
CDi 1000 | 1200W
CDi 2000 | 1225W
CDi 4000 | 1250W
