DCi Series
Power Amplifiers
page 9
Operation Manual
Set-up and System Configuration
Bridge Mode (16, 8, or 4 Ohm)
Typical input and output wiring, along with Attenuator and Mode DIP Switch settings are shown in Figure 7. Make sure the “Hi-Z” selector switches are in the OFF (down)
position and the Bridge (BRG) switch is in the ON (up) position. NOTE: Only the Hi-Z selector switches assigned to odd-numbered channels (1,3,5,7) are active in Bridge
mode; switches assigned to even-numbered channels (2,4,6,8) are disabled.
Figure 7 System Wiring Bridge Mode
Always route the input and output wires in separate bundles.
Summary of Contents for 4300
Page 32: ......
