INSTALLATION AND OPERATION MANUAL, ELECTRIC SELF GENERATING SINGLE AND
TWIN STEAM MIXER KETTLE, MODELS ELTM-40 TO 100 AND ELTM 40-2 TO 100-2
Part No. 10041R4
11
2018-08-08
4.0 OPERATION INSTRUCTIONS
WARNING: The kettle and its parts are hot. Use care when
operating, cleaning and servicing the kettle.
KETTLE
Ensure that the external electrical service to kettle is on.
Check pressure gauge for correct cold kettle reading. Reading should be in the green area
of the gauge indicating 25 - 30 In. Hg (630 - 730 mm Hg) of vacuum. If reading is not low
enough, follow VENTING procedure in Troubleshooting section prior to using kettle.
Place power switch to ON position.
Preheat kettle by placing thermostat knob
at ‘10' and wait until TEMPERATURE light goes off.
NOTE: Preheating should not be used when cooking milk and egg food
products which adhere to hot cooking surfaces. These foods should be placed
into kettle before heating has begun.
Add food to be cooked into kettle.
Place thermostat knob at required temperature setting from 1 to 10 coinciding with the
following table:
