80
Gas Monitor Bump
Test Report:
To print a bump test report for a specific bump test of a specific gas monitor on a
specific date, ensure the required date for the specific gas monitor serial number
is highlighted. The screen shown in
will be displayed automatically.
The bump test report shows the following information:
• Monitor Type
• Monitor Date (internal monitor date when tested)
• Monitor Time (internal monitor time when tested)
•
Monitor Serial Number
• Date of bump test
• Time of bump test
•
Overall Pass/Fail Result of bump test
•
Next bump test Due Date
Note: If the gas cylinder used for the bump test had the cross calibration option selected (see
) two % LEL values will be shown in the bump test report report for the flammable gas sensor. The
first value is the equivalent % LEL level of the gas used to determine a pass or fail result, the second
value is the actual % LEL level of CH4 in the cylinder.
It is then possible to print this report to a standard network printer by selecting the print icon.
Figure 62: Gas monitor bump test report
• Sensors Types Tested
• Gas Level Applied
• Units of applied gas
• Cylinder Expiry Date
•
Cylinder Lot Number
•
Sensor Pass/Fail Result of bump test
•
Sensor Pass/Fail bump test
Contents
Exit
Unpacking
Set-up
Operating I-Test
I-Test
Manager
Configuring
I-Test
Warranty
Overview
Contacts
Appendices
Troubleshooting
Specification