Crow CS-47 Link, Configuration Manual

Page: 21 / 29

CS-47 GSM Link - Configuration Guide Chapter 5 - Configuring the CS-47 Link Unit
18
‹
To configure the contact ID:
1. ȱ Click ȱ the ȱ
ȱ
button. ȱ
ȱ
The ȱ Contact ȱ ID ȱ Configuration ȱ window ȱ opens. ȱ
2. Using
Table ȱ 4 ȱ below ȱ as ȱ a ȱ guide, ȱ add ȱ Contact ȱ ID ȱ numbers. ȱ
3. ȱ Select ȱ Events ȱ to ȱ trigger ȱ Input ȱ 1. ȱ
Table 3: Contact ID Configuration Parameters
Button or Field Description
Event’s Filter Displays the available events that can trigger the CS-47
Link modem.
Add Add a new Contact ID number to the list.
Remove Removes the selected Contact ID number.
Property Enables you to edit the existing Control ID information.
Up/Down The top number is dialed first and if unavailable
continues to the next in sequence. Use these buttons to
move the numbers up and down the list so that you can
place them in the desired sequence.
Only while PSTN
Fail/Dialer Failure Enables the selected protocol ONLY when a PSTN/Dialer
failure is detected. Can be independently selected or
cleared for each protocol.
Loop-> Next
Next-> Loop CS47 link will sequentially dial 4 times to the first
selected Tel. num. and if there is no answer the CS47
will try 4 times as well to the next selected Tel. num.
This is a loop of 4 times that the CS47 dials sequentially
to each selected telephone number
ȱȱȱ Check ȱ the ȱ box ȱ to ȱ enable ȱ delivery ȱ of ȱ all ȱ events ȱ via ȱ all ȱ selected ȱȱȱȱȱȱ ȱȱȱ
ȱȱȱȱȱȱ Telephone ȱ numbers. ȱȱ
In ȱ this ȱ mode ȱ all ȱ events ȱ will ȱ be ȱ transmitted ȱ to ȱ the ȱ first ȱ selected ȱȱȱȱȱȱ
telephone ȱ number. ȱ On ȱ a ȱ successful ȱ delivery ȱ the ȱ system ȱ will ȱ stop ȱ