3
4
INSTALLATION
INSTALLATION
First shut off your water heating system then, with your mains stop cock closed,
open the lowest hot and cold taps in the house and allow to run until the cold storage
tank and pipes are empty (the hot water storage cylinder always remains full).
Where combination boilers are fitted it is only necessary to turn off the boiler and
shut off the incoming mains.
Fitting isolating valves to the inlet feeds is recommended for ease of maintenance.
INSTALLATION
Remember to turn off the mains water supply before connecting to any
existing pipe work.
Warning! Please check for any hidden pipes and cables before drilling
holes in the wall
!
Mounting plate
A recess must be made in the wall to accommodate the mounting plate, mixer and
flexible hoses.
Place the mixer in position, check to see if any alterations are needed to the existing
pipe work.
Secure the mounting plate into the recess in the wall.
Connect the water supply to the tap with hot water on the left and cold on the right.
(When viewed from the front).
Once you have satisfied yourself that there are no leaks, switch on the water heating.
!
Valve
Apply a narrow bead of clear silicone sealant around the back edge of the cover
plate and carefully press into position.
ATTENTION
Having first checked all new connections, turn on the mains stop cock, close all taps
except the new mixer and as the system starts to refill check for leaks.
WASHER
WASHER
FIXING SCREWS
MAIN OUTLET
(SPOUT)
MOUNTING PLATE
VALVE
COLD INLET
HOT INLET
WP120WNC
FIG. 2 INSTALLATION OF HANDLES
FIG. 1 INSTALLATION OF SPOUT
COVER PLATE
SPOUT
HEXAGONAL
KEY
SCREW
COVER
HANDLE
COVER PLATE
HEXAGONAL
KEY
SCREW
COVER