Remove the red protective
tape to expose the adhesive
1
2
3
PVC Strip
PVC Strip
Wall facing edge
of bath tub
Wall facing edge
of bath tub
l
Under floor access is required for plumbing of bathtub waste
•
It is recommended that ITD5135 be used for ease of
installation.
4
Installation
3
Installation - preparation
l
Waste connection is dependant on the site situation.
Final decision about installation of waste connection should be
taken by a suitably qualified installer.
l
Add the sealing flange to the edge of the bathtub which will sit
against the wall.
l
Once the sealing flange is attached to the bathtub, cut off the ends
to the appropriate length.
l
Prepare to add the sealing flange by separating the surfaces of the
strip in three steps.
5
Installation
l
Place the bathtub on two wooden blocks over the waste connections.
Connect both wastes, fill the bath tub with water and check for leaks.
l
Fit the bathtub and overflow waste as per the manufacturers
instructions.
WARNING: Do NOT overtighten the waste as this may cause long
term damage to the bath.
We recommend to use a torque wrench to tighten the waste by
using a torque force between 25Nm or 18.5 ft/lb and 50Nm or
36.8 ft/lb.
