Issue date: 093020
Warranty - This Crosswater London product is covered by a limited lifetime warranty. For full details, terms and conditions please visit our website.
For further information contact: Crosswater London, 393 Fortune Blvd., Milford, MA 01757
Toll free number: 844-XWATER-1 (844-992-8371) tel: 508-381- fax: 508-381-6068
www.crosswaterlondon.com
email: [email protected]
Once installed and sealed, DO NOT
use or get wet for 24 hours.
PVC Strip
Wall facing edge
of bath tub
Wall/stud
PVC Strip
Wall facing edge
of bath tub
Bead of silicone sealant
Tile/wall liner
Wall/stud
Installation
z
A water barrier has now been created between the PVC strip
and the bathtub.
z
Wall tiles can now be fixed onto the wall and down to the bathtub.
Cleaning Instructions
Installation
z
Finally, seal the bathtub around the floor with a bead of silicone.
Clean the bath regularly with non-abrasive soap and warm water. Fully rinse after cleaning.
While Clearstone is highly stain resistant, it is recommended that bath water containing additives such as oils or salts is always drained and
rinsed immediately after use.
Please note that hair dyes and color cosmetics (eg. mascara, lipstick, face powder) may leave a slight discoloration if not removed immediately.
If any strong chemicals come into contact with the bathtub, remove and rinse immediately.
Water temperature should not exceed 49˚C/120˚F.
For a fine scratch or a slight mark, use a 1500 grade sandpaper. Gently sand the area with water. For best results, limit sanding to the smallest
possible area around the scratch. Re-polish the surface afterwards using a neutral polishing compound or toothpaste. It may be possible to
polish very fine scratches away without using abrasive papers: scrub gently with a soft brush or plastic pad (not metal scouring pad) and a
mildly abrasive cream cleaner. Afterwards scrub the whole area with plenty of clean water and re-polish as before.
If the scratch or mark is too deep and cannot be repaired using the above method, it is possible to purchase a repair kit US-CRK. In order to
remove the scratches, follow the instructions included with the kit.
