2
Installation
l
This installation guide does not include details of waste
connection
.
F
inal decision about installation of waste connection
should be taken by a suitably qualified
contractor
.
l
Install the waste according to the installation instructions supplied
with the waste.
l
Place
the b
asin in desired position making sure waste hole is
aligned.
l
Apply sealant to
the
inside edge and place into position.
WARNING: Do NOT overtighten the waste as this may cause
long
-
term damage to the basin.
We recommend to use a torque wrench to tighten the waste by
using a torque force between 25Nm or 18.5 ft/lb and 50Nm or
36.8 ft/lb.
IMPORTANT:
Crosswater
London
cannot accept responsibility for any
injuries caused to those attempting to install this basin
without adequate and appropriate tools or resources.
l
Remove the basin carefully from the packaging.
l
Do not drag the basin over rough surfaces or sharp objects.
Lift and place the basin into position.
l
Do not drop the basin!
1
Installation - carriage
3
Maintenance
A simple routine of regular care will keep your vitreous china and fireclay products clean and fresh.
Rinse away any traces of soap and gently dry with a clean soft cloth after each use. A mild detergent, warm water and a soft cloth will remove
normal dirt and soap accumulations from surfaces.
Soft abrasive cleaners may be used on vitreous china and fireclay. Never use abrasive cleaners without water. Do not use caustic cleaners or
disinfectants as they can alter the surface finish and void the warranty.
Do not allow certain materials such as toothpaste, cologne, shaving cream, nail polish remover, vinegar, wine, drain and glass cleaners to
remain on the surface. Prolonged contact can alter surface finishes and void the warranty.
Issue date:
19112020
Warranty
-
This
Crosswater London
product is covered by a limited lifetime warranty. For full details, terms and conditions please visit our website.
For further information contact
:
Crosswater
London
, 393 Fortune Blvd., Milford, MA 01757
Toll free number: 844-XWATER-1 (844-992-8371) tel: 508-381-
0433
fax: 508-381-6068
www.crosswater
london
.com
email: technical@crosswater
london
.com
IMPORTANT: Basins are designed for installation with MPRO
vanities.
Basins are not suitable for wall-hung installation without
underside support. It is the responsibility of the installer to
provide adequate support.
Crosswater London cannot be held responsible for inadequate
wall-hung installation.
Mounting hardware for wall-hung installation not supplied.
