3
4
INSTALLATION
INSTALLATION
First shut off your water heating system then, with your mains stop cock closed, open the
lowest hot and cold taps in the house and allow to run until the cold storage tank and pipes
are empty (the hot water storage cylinder always remains full). Where combination boilers
are fitted it is only necessary to turn off the boiler and shut off the incoming mains.
Fitting isolating valves to the inlet feeds is recommended for ease of maintenance.
!
Remove the fixing nuts, plastic and rubber washers from the tap tails.
Insert the tails into the holes on the bath top making sure that the O ring and mixer base ring
are correctly positioned.
From beneath slide on the rubber washer, plastic washer followed by the nut.
Secure the tap finger tight with the nuts, check that the tap is correctly positioned to the rear
and tighten fixing nut. The tap needs to be fixed firmly but do not over tighten as damage
may be caused to the bathtub.
Connect the water supply to the tap with hot water on the left and cold on the right.
(When viewed form the front).
Once you have satisfied yourself that there are no leaks, switch on the water heating.
KL322DC
INSTALLATION
Remember to turn off the mains water supply before connecting to any existing
pipe work.
ATTENTION
Having first checked all new connections, turn on the mains stop cock, close all taps except
the new mixer and as the system starts to refill check for leaks.
MAINTENANCE
CAP
MIXER HANDLE
HEXAGONAL
KEY
SEAL
CARTRIDGE
MIXER BODY
CLEANING THE CARTRIDGE
The concealed cartridge should give trouble
free service, but in the event of any problems,
servicing is straight forward.
To remove the cartridge.
Pull off the cover cap and with an hexagonal key
loosen the screw, but do not remove it. Pull off the
handle. Using the correct size spanner unscrew
and remove the cartridge. Wash the cartridge with
clean running water and make sure that any
trapped debris has been removed. Dry and lightly
grease the seal (only use silicone grease) and
replace the cartridge followed by the handle.
CLEANING
The chrome and gold plate we use on our taps is very durable, nevertheless care
should be
taken when cleaning
them. They should be cleaned only with warm soapy water followed
by
rinsing with clean water and drying with a soft cloth. All finishes are vulnerable
to acid attack
and some strong substances such as
household cleaners, disinfectants,
denture cleaners,
hair dyes, wine making and photographic
chemicals can cause
the surface to go black or peel.
HOT
CONTROL
HANDLE
MIXER BODY
RUBBER
WASHER
RUBBER
WASHER
PLASTIC
WASHER
NUT
RUBBER
WASHER
PLASTIC
WASHER
NUT
FLOW STRAIGHTENER
COLD
CONTROL
HANDLE
BATHTUB
MIXER BASE
RING