10
11
Adding a Bed Shaker 520 to Your Radio Network
To add a Bed Shaker(s) to an existing home network, perform the following steps.
Select any alarm/unit on the existing network.
Press and hold
the button on the front cover
of the alarm. The red FIRE light (WARNING if CO
alarm)will flash rapidly and the alarm will sound
three tones.
Next, the yellow WARNING light will flash slowly.
Count to
5 flashes
of the yellow WARNING light
and release the button.
If done correctly, the blue RADIO light will now
slowly pulse, indicating the network is again ready
to receive additional alarms.
The unit has been successfully added to your
network!
To add the Bed Shaker 520, simply install the
supplied (3) Duracell DR123 into the unit.
Open the battery door on the underside of
the speaker unit, and place the batteries as
indicated.
The blue RADIO light will flash briefly, then the
alarm will chirp twice and all four of the lighted
icons will strobe on in succession.
Continue holding the button down.
If not, wait about 15 seconds and carefully repeat
these steps.
If the unit being added was previously used,
follow the steps on Page 14 to erase its network
data. Then re-open this alarm’s radio function
using steps 1-2 in this section.
Press the button on the original alarm and the
RADIO light will stop flashing, or after one minute
the RADIO light will stop flashing automatically
and the network will close.
Removing a Bed Shaker 520 from a Radio Network
In the event that a Crossfire alarm or product must be removed from your
network, the alarm’s network data must be erased from its memory.
Press and hold the button on the front cover of
the unit. The red FIRE light will flash rapidly and
the alarm will sound three tones.
Continue holding the button down.
Next, the WARNING light will begin to flash
yellow. Count
10 flashes
of the yellow
WARNING light and release the button.
The alarm will chirp twice and all four of the
lighted icons will strobe on.
Warning: At this point, all network data has
been erased from the Bed Shaker 520. The
Bed Shaker 520 performs NO FUNCTION
unless it is connected to a Crossfire radio
network.
The Bed Shaker will chirp once every 56
seconds and flash the blue RADIO light as
a reminder that it must be connected to a
network.
BedShaker Manual, Exigent Canada 2-17-16.indd 10-11
2/17/2016 5:49:08 PM
Summary of Contents for Bed Shaker 520
Page 10: ...18 19...
