Crossfer LS8T-230V, Owner'S Manual, Page: 8 / 14

Bleed the air out of the hydraulic system before
starting the log splitter. The cover of the hydraulic
oil tank should be loosened by some rotations until
air can go in and out of the oil tank smoothly.
Air flow thru the oil tank filler should be detectable
during the operations.
Before moving the log splitter, make sure the cover
of the oil tank is tightened to avoid oil leaking from
this point.
1. Transport Handle
2. Ram Travel Adjusting Rod
3. Split Wedge
4. Ram
5. Plug & switch
6. Control Levers Connection Bracket
7. Top Motor Shield
8. Motor
9. Side Bracket for Support Table
10. Table Lock Down Hook
11. Base Cover
12. Wheels
13. Base
14. Oil Tank Cover / Air Bleeder
15. Front Bracket for Support Table
16. Control Lever Guard
17. Adjustable Log Holder
18. Log Holder Adjusting Knob
8
SET UP AND PREPARATION FOR OPERATION
1. Pull Spring Pin (A) to remove the Lock Pin (B). Apply a thin coat of grease to both surfaces of the Control
Lever Guard as illustrated. Insert the Control Lever and Guard Assy and make sure the Control Lever End
goes into the slot of Connection Bracket (C). Lock the Control Lever and Guard Assy. down with the Lock
Pin (B) and Spring Pin (A). Follow the same steps to install the other Control Lever and Guard Assy on the
other side.
2. 3 installation positions available for the Support Table for different splitting length. At every installation
positions, Lock Down Hooks (D) are available. Insert the Support Table in the selected Brackets (E). Turn
the Lock Down Hooks (D) on both side by 90 degrees to lock the Support Table down.
3. Familiarize yourself with the controls and features of this log splitter in the illustrations.
A
B
C
Grease
D
E