2.4 Installation / Operation -
2.4.1 Installing and Operating the 210-01(Figures 2.1 to 2.3) -
1.) Place the 210-01 where desired. (Attach four rubber feet if desired.)
2.) For the -R rack mount option mount the 1 3/4” panel to a rack using
the four end screws on the rack panel.
3.) Connect the wall power supply to 115 VAC, 60 Hz and the power
supply 2.1 mm DC connector to the 210-01 (Figure 2.1)
4.) Observe that green power LED (DS1) is illuminated.
5.) Connect RF In, J3 of the 210-01 to the cable TV connector using a
75
Ω
cable.
6.) Observe that the green Carrier and Data LEDs are illuminated.
7.) Connect the external External Audio In to J4
8.) Connect the Audio Out, J3 to the external audio amplifier
9.) Set the Address BCD switches to the desired number
10.) Set rear panel Audio Level pot, R47 to the desired paging volume.
11.) Using a small flat blade screwdriver, CAREFULLY adjust the
external audio level through the hole on the top back of the chassis.
12.) Note the proper pages reach this location and check address setting
if there are any problems.
13.) ADDRESS TEST POSITION SETTINGS. The following Address
BCD Switch settings may be helpful for troubleshooting.
00 -Audio will be switched ON if a valid packet is received.
Note, the packet need not be addressed to the particular decoder.
98- Audio page forced OFF ( switched to external audio )
99- Audio page forced ON ( switched to paging audio )
2.4.2 Setting the Front Panel BCD Switch - The address for any
particular 210-01 is assigned via two front panel rotary BCD switches.
These switches provide a possibility of 100 settings, displaying 00-99.
These settings are assigned as follows:
00 Special function Audio will be switched ON if a valid packet is
received.
210-01 manual Rev B
Page 8
2/18/00
