1.2 Technical Characteristics
TABLE 1.1 1200-03 IF Processor Specifications
*
RX Input Characteristics
Impedance/Return Loss
50
/18 dB
Frequency
50 to 90 MHz
Input Level Range/1dB
0 to -80 dBm / +5 dBm
RX Output Characteristics
Impedance/Return Loss
FDM RX 50
/ 18dB; DIG1, DIG2 RX 75
/18 dB (with
5dB
attenuation on each channel)
Output Level, nom/max
-35 ± 10 dBm / -10 dBm
Output Level Adjust
-35 to -65 dB ± 10 dB at -35 dBm nominal
RX IF Mon Output Level
-35 ± 10 dBm
RX Channel Characteristics
Gain, AGC
-35 to +45 dB range
Frequency Response
±1.0 dB
TX Input Characteristics
Impedance/Return Loss
FDM TX 50
/ 18dB; DIG1, DIG2 TX 75
/18 dB (with
5dB
attenuation on each channel)
Frequency
50 to 90 MHz
Input Level Range
-20 to +5 dBm
Input Level Adjust
0 to -30 dBm with 0 dBm in
TX Output Characteristics
Impedance/Return Loss
50
/18 dB
Output Level Range/1dB
-50 to +5 dBm / +10 dBm
TX Channel Characteristics
Gain Adjustment
0 to -30 dB, each channel individually adjustable
Frequency Response
±1.0 dB
Group Delay
5 ns, max
TX Switch Characteristics
Isolation, Switch off
60 dB
Isolation, Port to Port
50 dB, all “ON” and
5dB attenuation on each channel
Switch Time
10 ms
Controls, Indicators
Front Panel Controls
SW1, SW2, SW3
DIG1 TX, FDM TX, DIG2 TX switches (2PDT)
SW4
LOCAL/REMOTE switch (2PDT)
Front Panel Indicators
DIG1, FDM, DIG2
Green LED indicates DIG1 TX, FDM TX, DIG2 TX are “ON”
OVERRIDE
Yellow LED indicates override of LOCAL control
LOCAL
Red LED indicates SW4 set to LOCAL control
DC
Green LED indicates power is supplied to the unit
Front Panel Monitors
J1, J2
RX AGC Monitor, TX IF Out Monitor
Other
IF Connectors
BNC, female
Connector, Control
DB9, female
Size
19 inch standard chassis 1.75”high X 14.0” deep
Power
100-240 ±10% VAC, 47 - 63 Hz, 30 watts max.
*+10 to +40 degrees C; Specifications subject to change without notice
1200-03 Manual, Rev. B
Page 4
01/08/09
