English
5
Initial Setup
Essential Setup
1. Place the unit on a flat and level surface. The selected location should be
stable and free from vibration.
2. Remove the tie-wrap that is holding the tonearm.
3. Place the slip mat on top of the turntable platter.
4. Connect the speakers to the
Spring clip speaker terminals
of the turntable.
5. Connect AC adaptor to the
Power Jack
of the unit.
Note: Do not plug the AC power adaptor to power outlet before all the assembly is
completed. Before turning the power on, make sure again all the connection settings
are correct. Always turn off the power when connecting or disconnecting.
Stereo System Connection
Spring clip speaker terminals
The spring clip speaker terminals deliver amplified, speaker-level signals as
output and should be connected with the passive speakers.
Aux Input Connection
You can connect an audio device to this unit and play your music through its
speakers. To do this, rotate the
Function Knob
to Aux In mode, connect the
3.5mm auxiliary cable between your audio device and the
Aux In Jack
of this
unit and start playing.
Turntable Operation
1. Rotate the
Power / Volume Knob
to turn on the power.
2. Set the
Function Switch
to PHONO position.
3. Set the
Speed Switch
accordingly.
4. Place the record on the turntable. Use the
45 RPM Adapter
if necessary.
5. Remove the stylus protector from the stylus assembly.
Note: To avoid stylus damage, make certain the included stylus guard is in place
whenever the turntable is being moved or cleaned.
6. Release the tonearm
Hold Down Clip
.
Note: when the turntable is not in use, remember to lock back hold down clip.
7. Use the
Cue Lever
to lift up the tonearm.
8. Gently move the tonearm over the record where play is desired to begin. Set
the
Cue Lever
back to the down position, the tonearm will descend slowly
onto the record and begin to playback.
