Visit us at
crlaurence.com
for international toll free information 5
A
C.R. LAURENCE Co., INC.
SAFETY INSTRUCTIONS
IMPORTANT GENERAL SAFETY TIPS!
1.
The tool should be unplugged when changing accessories.
2.
If you stall the tool, switch it off immediately.
3.
Periodically check the tightness of your collet chuck, especially during prolonged
use of the same accessory.
4.
After use, always disconnect your power tool.
5.
Do not attempt to repair the power tool yourself.
6.
Do not leave your tool or transformer unattended while switched on.
7.
The transformer must be plugged into an easily accessible main outlet close to your equipment.
8.
Always unplug the transformer before disconnecting your 12V tool.
9.
Do not attempt repairs on the transformer.
10.
Do not drop your transformer.
11.
After use, always disconnect your transformer from the main outlet.
12.
Do not use or store your transformer or 12V tool in damp or wet conditions.
USEFUL HINTS AND TIPS
1.
Your mini tool will become warm after prolonged use. When it does switch it off and allow
it to cool down.
2.
To ensure smooth running, the spindle should be oiled periodically.
3.
Do not apply too much radial pressure to the accessory bits while polishing, cleaning,
sanding, or grinding. By doing so you will put a strain on the spindle and adversely
affect the precision of the tool.
4.
Always work with a sensitive touch so as not to impede the efficiency of your mini tool.
5.
When drilling metal, always mark the drilling point with a center punch first, so that your
mini tool does not slip.
6.
Always ensure that you have maximum contact between the accessory shaft and
the collet chuck.
7.
Vary the speed on the tool for the work in hand. Use low speed for polishing and cleaning,
and high speed for engraving.
PLACING ACCESSORIES INTO THE TOOL
Always switch the tool off first. Hold the locking ring at the front of the tool down and undo the collet
chuck (counter clockwise). Insert the collet that matches the shaft size of the accessory to be used.
Place the collet nut over the collet and then insert the accessory shaft into the collet chuck ensuring
maximum shaft contact. Tighten the collet nut. (DO NOT USE PLIERS).
