6
Bicycle helmet SP-91
2. Adjusting the single-hand twisting fastener
The integrated size-adjusting system can be adjusted using a turning knob at the back of
one’s head (Fig. C):
• smaller = twist clockwise
• bigger = twist anti-clockwise
3. Adjusting the strap divider
• Open the strap divider (Fig. D).
•
The strap divider must be positioned in such a way, that the straps are taut but
comfortable. The strap divider must be below the ear, and the straps must not cover the
ears.
• Close the strap divider (Fig. E).
An open strap divider can lead to slipping of the helmet in the event
of an accident and thus to a loss of protection!!!
4. Adjusting the chin strap
• The chin strap (Fig. G.3) has been adjusted correctly if you feel slight pressure when
you open your mouth. The buckle shall not be positioned on the jawbone.
• If the chin strap (Fig. G.3) is too loose it must be pulled tight using the winding (Fig.
G.2) on the fastener (Fig. G.1).
• If the chin strap (Fig. G.3) is too tight it must be loosened also using the winding (Fig.
G.2) on the fastener (Fig. G.1).
Please note that you must always make sure that the fastener is
closed before you ride !!! (Fig. F)
Please be aware that the helmet can only protect if it fits properly.
Please try out different sizes and choose the one in which the helmet
fits comfortably and sits firmly upon your head.
5. Visor
•
Carefully pull out the pins on the visor from the pin holes on the helmet shell to
remove the visor (Fig. H).
Attention: The pin holes on the helmet can expand through excessive
use. in this case, the visor may no longer be used.
