15
The connection of the XLR 3 poles must be as follows:
pin 1---> function GND (SHIELD)
pin 2---> function SIGNAL -
pin 3---> function
Pls. ensure that the cables are properly connected.
Use shielded cable.
In order to protect the PCB housing from water penetration, it is strictly recommended to position
the DMX connecting plugs as illustrated below (see pictures 2 and 3).
5.2 Channels Indicatoion
pict.1
pict.14
pict.15
100%
75%
50%
25%
0%
CY
A
N
Y
E
LLO
W
MA
G
E
N
T
A
1
2
3
4
5
C H AN N EL
KO LO R AD O 4000
Lam p
on - off
D im m er
Black-out
Strobe
Yellow
C yan
M agenta
off
on
%
OP
T
ION
SEQUENCE
VALUE
Lamp On
0 ……126
Lamp Off
127 ……255
Channel 2 Dimmer/ Strobe
SEQUENCE
VALUE
Closed
0 ……5
Dimmer 100% - dimmer 0%
6 …...127
Open
128 ……159
Mechanical strobe speed 1
160 ……167
Mechanical strobe speed 2
168 ……175
Mechanical strobe speed 3
176 ……183
Mechanical strobe speed 4
184 ……191
Electronic strobe speed 1
192 ……199
Electronic strobe speed 2
200 ……207
Electronic strobe speed 3
208 ……215
Electronic strobe speed 4
216 ……223
Electronic strobe speed 5
224 ……231
Electronic strobe speed 6
231 ……239
Open
240 …...255
Channel 1 Remote switch lamp On-Off (if option 3 on)
Channel 3,4,5 Yellow, Cyan and Magenta
These channels control the filters insertion proportionally
SEQUENCE
VALUE
Open
0
0%…99%
1 ……254
Full 255
Warning: a prolonged use of the electronic strobe effect will considerably
reduce the lamp life. It is strongly advisable not to use the electronic strobe
effect longer than 10 minutes also to prevent the activation of the thermal
protection (de-activation of the electronic strobe effect, 100% lamp on).
OPTION
ORDER DIRECTLY TODAY AT:
www.BulbAmerica.com
or CALL TOLL FREE 888-505-2111
