33
Special precautions should be taken on any installation prone to
electrolyze phenomena. Electrical standard
requires a battery
switch as close as possible to the batteries.
Precautions regarding lightning
In areas highly exposed to lightning, it may be advisable to install
a lightning arrestor upstream of charger to safeguard it against
irreversible damage.
Precautions regarding overheating of the appliance
This appliance is designed to be mounted on a vertical wall or
partition as indicated herein.
It is imperative that there be a gap of 150mm around the shore-
power unit. The installer must ensure that the temperature of
the air at the input is lower than 65°C in extreme operating
conditions.
Measures should also be taken to allow evacuation of hot air on
either side of the shore-power unit.
It’s strictly forb
idden to put any device on or against the shore-
power unit.
The shore-power unit must not be installed near a heat source; it
should be installed in a well-ventilated area. The shore-power
unit's air inlets and outlets must not be obstructed.
Attention hot surface: do not touch the shore-power unit
during and after its operation (burn hazard).
