16
Warning: Never clean the steam oven with strong cleaning solvent, banana oil, gasoline, lapping
powder or metal brush.
1.
Before cleaning, steam oven must be turned off and unplugged from power supply.
2.
Keep steam oven clean regularly, if food or soup splash onto cavity, please wipe it by wet cloth, not by
abrasive material. If oven is very dirty
，
please use steam function for 15 minute and use soft cleaning
solvent to clean.
3.
Please pour pure water or distilled water into tank for cooking. Running water will cause scale (mineral
deposit) to cavity.
4.
Water tank should be checked at least once per month, make sure the rubber seal ring in good condition,
please take the tank out horizontally, and put it back after cleaning.
5.
After cooking finished, the water left in water collector and cavity need to clean up immediately.
6.
The door gasket should be cleaned regularly with soft cloth.
7.
If control panel glass should be clean with cloth. Crude, abrasive cleaning solvent may cause damage.
8.
If the steam oven is not intended to be used for a long time, it should be unplugged; clean the cavity, and
then put in dry environments without moisture and corrosive gas.
9.
Steam oven need to be serviced by trained person from manufacturer or local agent, dismantled and
modification by anybody else would be dangerous and void the warranty.
10.
Ensure that the appliance is switched off before replacing the lamp bulb to avoid electric shock. Remove
the lamp cover, and use only the recommended lamp bulb supply by the manufacturer or agent.
11.
It is prohibited to clean the oven door’s glasses with abrasive or sharp metal, it would cause the glass
damage or broken.
12.
Please use soft material (such as cotton cloth material) to clean the food tray, oil collector and rack,
don’t use hard materials (such as steel wool) because they are would damage the cooking wear’s
protective layer.
13.
Disposal must be carried out in accordance with local environment regulation for waste disposal. For
more detail information about treatment, recovery and recycling of this products, please contact your
local city office, your household waste disposal service.
FAILURE CLEAR WHEN WARNING SIGNAL ARISE
Code
Description
Reasons
ER1
Cavity over heat protection.
Temperature in cavity over 220
℃
ER2
Steam generator over heat protection.
Temperature in steam generator over 180
℃
ER3
Heating failure protection.
Continue working for 3 minutes and temperature
in cavity still below 30
℃,
abnormal function.
ER4
Steam plate low temperature protection.
Continue working for 3 minutes and temperature
still below to 30
℃
, abnormal function
ER5
Sensor connection failure.
Cavity or steam generator's sensors connection
loosing.
ER6
Temperature sensor failure.
Cavity or steam generator’s sensors malfunction.
