The CrimeStopper remote starter must be configured to accept the MYCAR telematics device. F
ollow these steps AFTER you have completed installing and testing the
remote start.
1.
With your vehicle ignition on the 'on' position (but not started) press the red programming button that came with the remote start 5 times. You will hear 5 clicks
from the remote start module - this indicated you've entered Options Programming.
2. Now press the red programming button SLOWLY 30 times. You will hear a click after each press.
3.
Once you've reached 30, set the
“Smart Phone Baud rate”
to
9600 to accept the
MYCAR
commands.
If you have an RS3 or RS4 remote start, do this by pressing the
'lock' button on one of your Crimestopper remotes. If you have an RS1 or RS0, you can toggle through the baud rate programming options by pressing the brake
pedal. There will be single click from the remote start brain after the correct setting has been selected. Regardless of whether your programming with the remote
fob or the brake pedal, turn the ignition off after you've selected the correct setting. Programming is now complete.
Step
3
:
Configure the Crimestopper
r
emote
s
tart
Complete Options Programming instructions can be found on Page 1 of the Crimestopper Installation Guide.
Connect the
MYCAR
telematics device by following the
remote starter connection guide as shown in the wiring guide on the next page
Step
4
:
Plug the MYCAR device into your
remote start
1. In the MYCAR package, locate the main wiring harness and the adapter labeled "HRN-LLRS-01" and the main power harness "HRN-MCAR-01". Plug the white 4-
pin connector from the HRN-LLRS-01 adapter into the 4-pin white receptacle on the end of the remote start module.
2. Plug the blue end from the HRN-LLRS-01 into the blue receptacle in the HRN-MCAR-01 main harness.
3. Use electrical tape to tape of the bare wire ends of the HRN-MCAR-01. Make sure none of the wire ends touch each other.
Once the MYCAR module is plugged into the remote start system, a LED indicator will show you what networks you are connected to. (see below guide)
LED Status
Green LED:
Cellular network
Red LED:
GPS network
OFF:
No network communication
Flashing:
Connecting to a network
Solid:
Connection is established
NOTE: The vehicle may need to be outside in an open area in order to connect to a cellular and/or GPS network.
For technical support or installation questions, call Mypushcart.com at 520.572.2220. Our business hours are Mon-Fri, 9:00am - 5:00pm Arizona time.
