OPTIONS PROGRAMMING
2. EZ-30 ONLY Auto Lock/Unlock:
This option controls whether the doors will automatically lock/unlock on your vehicle when driving or with turning the
Ignition ON/OFF. If the Auto Lock feature is turned on, and the system is in Tach mode, then the doors will lock as the
engine RPM’s increase (driving). If the Auto Lock feature is turned on, and the system is in Smart Tachless mode, then
the doors will lock when the Ignition is turned on. When the Auto Lock feature is turned on, the system will unlock the
doors when the Ignition is turned off. With this feature OFF, the system will not automatically lock or unlock the vehicle.
3. OEM Disarm / Unlock Pulse:
Some vehicles (namely Nissan and VW) require a shorter setting prevent the vehicle from attempting to roll down the
windows due to the length of the UNLOCK and/or DISARM pulses. Use this option to SHORTEN the OEM
Disarm/Unlock Pulses should your vehicle require this. Symptom: Windows will slightly vent or begin to roll down when
unlocking.
4. EZ-30 ONLY Double Unlock Pulse:
The unit will send 2 unlock pulses when the #2 Unlock button is pressed. This feature may be required for interfacing
this alarm with an existing Factory Keyless Entry or Alarm system in a vehicle. These systems are found on some
Nissan, VW, Toyota, and Lexus vehicles.
5. EZ-30 ONLY Lock During/After Remote Start:
This option controls whether the unit will automatically lock during and after a remote Start abort or time elapses.
6. Diesel Glow Plug Delay:
This option allows the system to work in a diesel vehicle. You can program a specific delay time before cranking to allow
for the glow plugs to warm up once you choose a delay time if 10, 20 or 30 seconds, the system will ALWAYS wait for
that time period before cranking, even if the glow plugs warm up first.
7. Remote Start Run Time:
This option controls the engine run time for remote start. Select your choice of 12, 24, 36, or 48 minutes. The default
setting is 24 minutes.
8. Option Reset: (RESTORE TO DEFAULT)
This option allows you to restore all programmable options to factory default values. Go to the option #8 and press the
Unlock Button #2 on the remote. (For EZ-10 Model, Tap the brake pedal 2 times.) The unit will flash the lights 2 times
and all values will be reset to factory original settings. Default values are marked with asterisks in the chart on page 14.
15
