COMPONENT MOUNTING
SIREN MOUNTING:
Mount the siren under the hood to fender-well or other body surface with the open end facing
downward. Run the red siren wire through the firewall using a rubber grommet. Ground the black wire to the body
metal near the siren.
LED:
Mount the red
LED
in a visible location on the dashboard or console. Drill an 11/32" hole at the chosen location.
Shock Sensor:
Mount the included shock sensor with wire ties to an under dash wire harness or fasten with screws to
firewall or side paneling.
Override/Program Button:
Mount the
Override/Program
push-button in a hidden location easily accessible to the
user in case the system must be disarmed without the use of the transmitter. This switch is also used to program
certain features.
WIRING
MAIN HARNESS: 10 PIN 18 GA. WIRES
WHITE WIRE: +12V FLASHING PARKING LIGHT
OUTPUT (Optional)
Connect to switched parking light wire at back of light switch. If this is not possible, connect directly to one of the
parking lights at the front of the vehicle. European vehicles require separate right and left circuits. Use a dual relay or
2 diodes to separate the output signal.
RED WIRE: +12V POWER INPUT (15 amp fuse)
Connect to +12 Volt source with supplied fuse & holder. Recommended location for this connection is at the vehicle
battery positive terminal.
BROWN WIRE: (+) SIREN OUTPUT (2 Amp Max.)
Connect to RED siren wire.
BLACK WIRE: SYSTEM CHASSIS GROUND
THIS WIRE MUST BE CONNECTED TO CHASSIS METAL OF THE VEHICLE. Scrape away any paint or dirt from
the connection point to ensure a good connection. We recommend the kick panel area for your ground point.
ORANGE WIRE: STARTER KILL / NEGATIVE ARMED OUTPUT (500mA Ground)
Ground output when system is armed. This output is used for disabling the starter or to activate other devices such as
scanner LED’s, window modules, voice modules etc. For starter kill, cut starter wire and connect between 87A and 30
on relay. Connect orange wire to 85 and connect 86 to an Ignition source that has voltage in the ON and CRANKING
position.
CARJACK OUTPUT: When the system is programmed for Carjack operation, this output also turns on 8 seconds after
the siren trigger for activation an additional sounding/signaling device. Use with a relay triggered only by Ignition ON!
3
